Soldering in nitrogen or vapor phase environments can increase the likelihood.

Subtle component lifting can be an issue to find during inspection. Most modern AOI systems should be able to detect drawbridging on small passive and active parts. Old systems may struggle with defects like the two shown in FIGURE 1.

Figure 1. Passive parts printed with excessive solder or on incorrect pads are more susceptible to lift.

There are many papers on lifting of parts during reflow and many suggestions on the root causes. In our experience, the most common reasons are excess solder paste, an excessively thick stencil, or poor pad design. These issues are exaggerated by fast wetting, as seen in nitrogen and vapor phase soldering. To be clear, nitrogen or vapor phase do not cause lifting; they just increase the possibility of component lift.

We have presented live process defect clinics at exhibitions all over the world. Many of our Defect of the Month videos are available online at youtube.com/user/mrbobwillis.

Bob Willis is a process engineering consultant; This email address is being protected from spambots. You need JavaScript enabled to view it.. His column appears monthly.

• Prev
• Next