BANNOCKBURN, IL – IPC today issued support for the 2021 National Defense Authorization Act (NDAA) provisions that would bolster the resiliency and security of the electronics manufacturing ecosystem, including PCB fabrication and PCBA.

These provisions, approved in both the US House and Senate, aim to improve the security of electronics purchased by the Defense Department. Excerpts from a blog post argue the following:

“The NDAA provisions aim to improve the security of electronics purchased by the Defense Department by developing an affirmative list of allied, trusted countries from which the DoD can source those boards and assemblies. The United States should not be sourcing electronics for national security systems from countries it deems a current or potential security threat. Nor should any other country, for that matter.

“Today, without this requirement, there are potential national security risks associated with systems that are built with PCBs and PCBAs from sources that are beyond the visibility of the DoD. These risks have been well documented by the Defense Department and outside experts.

“The opposition fears the new requirements will disrupt their established supply chains in countries that are not affirmatively covered. But the provisions explicitly authorize the Secretary of Defense to add countries to the list of locations from which PCBs and PCBAs can be sourced. And, with over $10 billion of PCB manufacturing today in allied countries and the US, there is ample capacity today to meet DoD demand for military and commercial off-the-shelf electronics.

“In addition to downstream electronics industry support, the provisions have over four dozen supporting members of Congress from both sides of the aisle in the House and the Senate. Not a single member of Congress has risen in opposition.

“Moreover, both the full House and Senate have voted to include these provisions in the bill, so in keeping with committee precedent, the broad parameters of issue are settled.

“The NDAA provisions offer the ancillary, but meaningful, benefit of strengthening supply chain resiliency by growing the market for electronics manufactured in the United States and its allies. In fact, US CEOs have indicated a desire to grow their manufacturing operations in the United States but are hedging for the moment. They are waiting for the passage of the NDAA and the demand signal it will send.”

PCB West Virtual 2020 has more than 125 hours’ worth of technical sessions on printed circuit design and manufacturing available through Oct. 12.  pcbwest.com 

• Prev
• Next