Pros and cons – and costs.

It’s almost inevitable that a component that works well and lasts a long time will eventually be put on a list of parts not to be specified for mass production. Newer, better parts are on the way. The thinking goes that the microcontrollers and other devices on a board are already fine-pitch, so another one can be accommodated. That’s how we end up with those five-pin regulators with a tiny diamond-shaped pin trapped between four beveled rectangles.

Advantage: Component-to-component spacing. The via-in-pad trick enables high component density by enabling routing that is 100% internal to the board, with no exposed traces. The space normally set aside for the fan-out via can be used for the next component with the following stipulations:

• Test access is maintained
• Rework clearance (for desoldering)
• Electrical isolation (shielding)
• Thermal considerations (heat sink, heat pipe)
• Mechanical interference (headroom)
• Pick-and-place accuracy.

To continue reading, please log in or register using the link in the upper right corner of the page.